KISAE HS 1800-60 Home Solar Kit - Manual (Page 8)

Page 8

Remove the opaque sheet or flip the solar panel with solar cell surface facing
upwards. Adjust the mounting fringe of the solar panel to have the solar cell surface
facing directly to the sunlight to achieve the maximum power. When sunlight is
available, the solar charge indicator should automatically turn on
and the “Solar
Charge Indicator” should either flash or solid depending on the battery status.
NOTE: It is recommended to always charge the internal battery to a 100% state-of-
charge, as shown by a steady green on Solar charger indicator.
Disconnect Solar Panel from Unit:

Cover the solar panel with an opaque sheet or flip the solar panel with the solar cell
facing a flat ground to minimize the output voltage to zero volts.

Verify the Solar charge indicator is off.

Disconnect the solar cable connector from the solar input port of the unit.
Install a Second Battery Box: (optional)
Connect the unit with a second battery box (P/N HSK BX60) will double the unit run
time. Follow the detail installation guide provide with the second battery box for
second battery box installation. See also below a brief guideline to access the built in
auxiliary DC input port on this main unit and how the secondary battery box is
connected.

Please be sure the AC power cord is unplugged and the unit is turned off.

Remove the top right panel by unscrewing the two screws located on the top right
corners of the panel. The auxiliary port is located inside the compartment.

Place the optional battery box (P/N HSK BX60) on the right hand side of the main
unit.

Ground the two battery boxes together and to earth ground by using the supplied
ground cable through the
“Grounding Electrode Terminal”

Take out the auxiliary DC input port from the main unit and connect it to the second
battery box output port.