LOCKSTATE LS-19EPL - Manual (Page 2)

5. CODE DISPLAY AND BUZZER CONTROL
Display control: By pressing the 'C' key and the '3' key at the same time, you can set the LCD display to
either show the code as it is entered or not show the code as it is entered. When display reads ‘dP----‘ the
codes will not display when entered. When the display reads ‘dPCodE’ codes will display when entered
.
Buzzer sound control: By pressing the 'C' key and the '6' key at the same time, you can turn on or off the the
buzzer sound when the safe is opened. When the display reads ‘bUZZEr’ the buzzer will sound. When the
display reads ‘SILENT’ the buzzer will not sound.
6. BATTERY REPLACEMENT WARNING
To test the batteries press the ‘E’ key. If the batteries are good the display will show ‘HI-BAT’. If the
batteries are low the display will show ‘LO-BAT’ and you should replace the batteries.
NOTE: When the batteries are low, each time the safe is opened the display will read ‘OPEN ‘ and ‘Lo-
bAT’ alternating. Also, when the batteries are low, each time the safe is closed the display will read ‘CLOSE’
and ‘Lo-bAT’ alternating.
7. REPLACING THE BATTERIES
The safe requires 4× size ‘AA’ batteries. To replace the batteries, open the safe, remove the battery cover
on the back of the door, and replace the old batteries. Make sure the batteries are inserted with the correct
corresponding polarity. After changing the batteries, the user code of the system will revert back to the
factory preset user code ‘000000’. However, the current master code will remain in memory. Use of alkaline
batteries is recommended.
8. OVERRIDE INSTRUCTION TO OPEN THE SAFE MANUALLY
For your convenience, this safe has a manual override system in case you forget your combination or the
batteries die. To open the safe manually, use a screw driver to pry off the round plastic cover situated to the
right of the keypad (see “A” in diagram 1), exposing the keyhole underneath. Insert the key into the keyhole
and turn it clockwise to retract the bolts and open the safe door.
Note that the motor will NOT work when the override key is in the keyhole and the safe is in the UNLOCKED
status. In this case, the LED display will read ‘Error’. To remove the override key, with the door open turn
the key counter-clockwise and take it out.
9. INSTALLING THE SAFE
This safe can be secured to the floor, on a wall or in a closet. There are pre-drilled holes in both the bottom
and the back of the safe for mounting. To secure the safe, with the safe door open, hold the safe over the
exact spot where it will be mounted and use a pencil to trace the pre-drilled holes on the floor or the wall.
Remove the safe and drill a hole in each marked spot and insert the anchors into the drilled holes. Now,
again place the safe where it will be mounted (door open) and screw in the mounting bolts into the anchors
in the drilled holes from the inside of the safe.