LOCKSTATE LS-20ED - Manual (Page 2)

If you or an intruder tries to open the safe with an incorrect code, you will hear a beep with
the display showing ‘Error’ and the safe will not open. If an incorrect combination code is
used 4 times consecutively, the display will show ‘Error’ and a buzzer will sound for
approximately 3 minutes. The correct code cannot be entered until after this 3 minute delay.
The override key can however be used to open the door during this three minute delay. If the
key is used to open the door, the buzzer can be silenced by pressing the red button on the
safe door.
Programming the user code
A. With the door of the safe open, press the red button located on the inside of the door near
the hinge (see ‘(b)’ in diagram 2) and the display will show ‘SET CodE’.
B. Now enter a new user code (from 3 to 8 digits) and confirm by pressing the ‘START’
button. After hearing a series of beeps, the display will show ‘IN’ and the numbers in your
new user code indicating that the new user code is confirmed.
If you do not want the display to show your codes or numbers when you open the safe,
press the ‘START’ button twice at the beginning of the opening process.
5. BATTERY REPLACEMENT WARNING
To test the batteries, press the ‘START’ button. If the batteries are low, the display will show
‘Lo-BAE’, and you should replace the batteries. Alkaline batteries are recommend.
6. REPLACING THE BATTERIES
The safe requires 4 size ‘AA’ (1.5V) batteries. Open the safe, remove the battery cover on
the back of the door, and replace the old batteries. Alkaline batteries are recommended.
7. OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, this safe has a manual override system in case you forget your
combination or the batteries die. Use a screw driver to pry off the oval-shaped plastic cover
situated to the right of the keypad (see “(a)” in diagram 1), exposing the keyhole underneath.
Insert the key into the keyhole and turn it counter-clockwise. Now, leave the key in the
turned position and turn the knob clockwise to retract the locking bolts. You can follow these
steps to manually open your safe anytime.
8. INSTALLING THE SAFE
This safe can be secured to the floor, on a wall or in a closet. There are pre-drilled holes in
both the bottom and the back of the safe for mounting (see diagram 3). To secure the safe,
with the safe door open, hold the safe over the exact spot where it will be mounted and use a
pencil to trace the pre-drilled holes on the floor or the wall. Remove the safe and drill a hole
in each marked spot and insert the anchors into the drilled holes. Now, again place the safe
where it will be mounted (door open) and screw in the mounting bolts into the anchors in the
drilled holes from the inside of the safe.