Ransburg Turbodisk Fairing Assembly 70158 - Manual (Page 11)

4. Slide the bulkhead flange 70147 (assembled to
the 70155 bulkhead) over the ram flange 70381
and loosely secure with two (2) 8156-28C screws
(with two (2) 7776-07 lock washers in place). The
screws should just engage the ram flange.
5. Place the previously removed 70148 insulat-
ing cover over the insulator so that the domed
end faces the turbine. Insert the insulator into
the 70381 ram flange until the two (2) 8156-28C
screws will engage the two (2) screw holes in it.
The turbine air inlet MUST be facing the center of
the loop opening. Secure the screws. Loosen the
two (2) clamp screws in the ram flange. Rotate
the entire assemby until tube and cable slot in the
side of the bulkhead is in line with the center line
of the loop opening. Secure the clamp screws to
hold it in this postion.
8
Turbodisk Fairing Assembly - Installation
AU-82-01.3
Ransburg