Ransburg Turbodisk Fairing Assembly 70158 - Manual (Page 12)

6. Slide the insulating cover 70148 into position in
the blulkhead and secure it in place with the two
(2) plastic screws previously removed.
7. Pass all of the service lines through the slot
in the side of the bulkhead. Spiral Wrap (3923-
02) or some other NON-CONDUCTIVE material
should be used to bundle these lines. Make all
of the proper line connections (air, paint, and high
voltage) to the valving and motor. Loosen the
plastic screws in the bulkhead line clamp, press
the two halves together and secure the screws.
Place the 70157 fairing in position so that it will
slide over the entire applicator assembly. Mark
the vertical center line position of ht efour (4) lip
reinforcements on the outside of the fairing.
8. Slide the fairing over the assembly until it is
tight against the turbine housing. Drill and tap
holes through the fairing and bulkhead at each of
the four (4) reinforced points. Secure the two ele-
ments with the four (4) 9317-24C plastic screws.
Place the disk on the rotator shaft and secure.
9
Turbodisk Fairing Assembly - Installation
AU-82-01.3
Ransburg