Ransburg RMA Dual Purge Direct A12868 - Manual (Page 15)

RMA-303 Dual Purge Direct Charge - Introduction
LN-9267-11.3 12
Mechanical (Continued)
Maximum Fluid Pressure Supply
Paint: 200 psi (1379 kPa)
Solvent: 150 psi (1035 kPa) Fluid Flow Rate: 25-700
cc/min. (300 cc/min. maximum for 30mm Bell
Cup)
Bell Cup Cleaning Time
(Internal/External): 2.7 sec. (approx.)
Color Change Time: Dependent on system configuration, fluid pres-
0 sures, fluid viscosity, fluid line lengths, etc.
Speed Readout: Magnetic pick-up, unidirectional fiber optic
transmission
Atomizer Replacement Time: Less than 5 min.
Bell Cup Replacement Time: Less than 2 min.
Minimum Control Equipment
Requirements: (Versions listed or higher)
MicroPak LECU5004-11 (V.3.84)
Atomizer Module A11925-00 (V.0.4)
I/O Module A11435-00 (V.1.4) (0.01V) (4-20 mA)
* Specifications and ratings based on testing at sea level standard conditions.