Ransburg LEPS5002 Power Supply for MicroPak - Manual (Page 18)

Figure 5: Troubleshooting Guide (Continued)
General Problem Cause Solution
Erratic High Voltage
Output (All Outputs)
-or-
Power Supply Continu-
ously Overloads
Erratic High Voltage
Output (Single Output)
1. Control unit bad or not
configured properly
2. Bad low voltage cable
or cable connections
1. Bad high voltage elec-
trical contact or resistor
failure
1. Refer to the MicroPak service literature
for troubleshooting procedures.
2. Make sure that the low voltage cable,
74947, is plugged into the power supply
correctly and that the electrical contacts
are clean.
Make sure that all connections to the
MicroPak Control Unit are correct and
secured at terminal blocks.
1. Switch the HV output cable to an un-
used output if available.
LEPS5002 Power Supply - Maintenance
15
Ransburg
CP-98-02.3