Ransburg, Password protection, Operator interface – Ransburg HV Controller A12311 User Manual

Page 10: Switches, Led's

Advertising
background image

PASSWORD

PROTECTION

High Voltage Controller parameters will be pass-

word protected to prevent an unqualified operator

from changing the values.

OPERATOR INTERFACE

The High Voltage Controller has a physically

simple operator interface consisting of three (3)

LED's (Light Emitting Diodes), three (3) switches,

six (6) buttons, and a four line twenty character

(4 X 20) alpha/numeric display.

SWITCHES

Figure 2: Password Screen

Figure 3: Power Switch

Power Switch

The rocker switch on the left and the LED directly

above it are for power On/Off selection and dis-

play. The green LED is on when the power is On

to the controller.

Local/Remote Switch

This is used to determine if the Local (Front Panel)

controls have priority or if the Remote (Ethernet

Connection) controls have priority. If the switch

is up (Local Mode) the Front Panel controls may

change parameters, enable or disable the high

voltage, and clear faults. The Remote Ethernet

connection may look at parameters and values,

but may not change them or enable/disable the

high voltage output. If the switch is down (Remote

Mode) the opposite is true except that the Front

Panel switch may be changed to local Mode at

any time to disable the Remote Controls and to

enable the Local Controls.

HV On/Off Switch

This is a floating toggle switch. It is active if the

Local/Remote mode switch is in Local. It is used

to enable and disable the High Voltage output

and to clear system faults. When the System

Checks and Current Status are OK flipping the

switch to the up position (HV On) will enable High

Voltage Output (see "Figure 3 - Power Swtich"

in this section). Flipping it to the down position

(HV Off) will disable the High Voltage Output. If

there is a system fault, flipping this switch to the

OFF position (also known as the Reset position)

it will reset (clear) any faults currently detected

by the system.

LED'S

Power LED

If the Green Power LED is on, then the system

power to the controller is On.

High Voltage Controller - Introduction

8

Ransburg

LN-9623-00.1

Advertising