Ransburg Serial Digital Module 76911 - Manual (Page 6)

LN-9257-07.1 3
Serial Digital Module - Safety
Improper operation or mainte-
nance may create a hazard.
Personnel must be properly
trained in the use of this equip-
Personnel must be given training in accordance with
the requirements of NFPA-33.
Instructions and safety precautions must be read
and understood prior to using this equipment.
Comply with appropriate local, state, and national
codes governing ventilation, fire protection, opera-
tion maintenance, and housekeeping. Reference
OSHA, NFPA-33, and your insurance company
General Use and
Maintenance
Electrical
Equipment
High voltage equipment is uti-
lized. Arcing in areas of flamma-
ble or combustible materials may
occur. Personnel are ex-posed to
high voltage during operation and
maintenance.
Protection against inadvertent
arcing that may cause a fire or
explosion is lost if safety circuits
are disabled during operation.
Frequent power supply shutdown
indicates a problem in the sys-tem
which requires correction.
An electrical arc can ignite coat-
ing materials and cause a fire or
explosion.
The power supply, optional remote control cabinet,
and all other electrical equipment must be located
outside Class I or II, Division 1 and 2 hazardous
areas. Refer to NFPA-33.
Turn the power supply OFF before working on the
equipment.
Test only in areas free of flammable or combustible
material.
Testing may require high voltage to be on, but only
as instructed.
Production should never be done with the safety
circuits disabled.
Before turning the high voltage on, make sure no
objects are within the sparking distance.
AREA
Tells where hazards
may occur.
HAZARD
Tells what the hazard is.
SAFEGUARDS
Tells how to avoid the hazard.