Ransburg 9060 HV Classic Controller 80130-XXX - Manual (Page 12)

9060 Classic High Voltage Controller - Introduction
7 CP-13-06.2
INTRODUCTION
GENERAL DESCRIPTION
The Ransburg 9060 High Voltage Control-
ler
(80130-XXX) is used to provide high
voltage for electrostatic application equipment.
It uses a combination of proven high voltage
generation technology and microprocessor-
based control. It uses a variable voltage
output to drive a cascade that amplifies the
voltage to a high kV level. It also uses
current feedback information to maintain the
desired set point. The processor circuitry
provides the maximum in applicator transfer
efficiency, while maintaining the maximum
safety.
The 9060 Controller selection and adjustment
of set point values is performed from the
controller front panel. The triggering of the HV
is initiated by the airflow switch built into the
controller which senses airflow triggered by a
standard handgun.
SAFETY FEATURES
When used with the appropriate applicators
and cascades, the Ransburg 9060 High
Voltage Controller provides maximized opera-
tional safety. The protections include detection
of Ground Faults, Cable Faults, Feedback
Signal Faults, Overvoltage, and Overcurrent.
The microprocessor circuits provide a con-
trolled output load curve, which limits the high
voltage output to safe levels while monitoring
control and feedback signals for unsafe
conditions. Maximum operational safety is
obtained when the correct applicator settings
are used and when safe distances between
the applicator and target are observed and
followed. The maximum efficiency of the high
voltage controller is based on load.
DISPLAYS
The front panel displays the high voltage set
point as well as a reading of gun current out-
put. The gun current is derived from feed-
back signals between the controller and the
cascade.
Figure 1: 9060 High Voltage Controller
Part #: Description
80130-21X Vector R70AS Handgun
80130-31X Vector R90AS Handgun
80130-41X Vector AA90 Handgun
80130-51X Vector R90AS Waterborne Handgun
The 9060 High Voltage Controller (80130-
XXX) is available as follows: