Ransburg MCV Series Module Color Changer 78011-XX - Manual (Page 16)

Air Pilot Hose
Each color changer valve requires a 5/32” (4mm)
pilot hose to activate the color valve. This is a
push to lock connection and no hose termination
is required.
Fluid Output Hose
The fluid output hose of the color changer has
a 3/8” NPS (M) Fitting. For safety and solvent
savings it is recommended that a hose be used
between the color changer and the spray device.
Figure 6: Hose Feature Locations
Weep Ports
Weep ports for the microvalve are located in each
“slice” of the color changer. These ports will al-
low any fluid to exit the valve block should a seal
failure occur. If fluid is present outside this port,
maintenance will be required on the microvalve.
Fluid Inlet Circulating Hoses
A fluid hose connects to the 3/8” NPS (M) fitting
on each IN and OUT tube of the color changer. It
is recommended that a 1/4” to 3/8” ID nylon hose
be used for these connections. Each hose ter-
mination for connection to the stack must have a
3/8” NPS (F) swivel connection.
NOTE
> IN and OUT hoses
CAN be reversed
on the color changer since ports are tied
together.
MCV Color Changer - Operation
CS-01-01.8 13
Ransburg