Ransburg MCV Series Module Color Changer 78011-XX - Manual (Page 18)

>
Be careful of residual fluid pressure or
solvent pressure in the line. Cover over the
area where the valve slice is being removed
to prevent any solvent or paint from spraying
on you.
W A R N I N G
!
>
Prior to servicing the unit, insure that all
fluid pressure is relieved to atomsphere. A
solvent purge should be performed if pos-
sible.
W A R N I N G
!
1. Insure all pressure is bled off the system. If
possible, flush the block with appropriate solvent.
2. Using the clip removal tool (78078-00), push
on the installed locking clip with the “V” cut as
shown in Figure 9.
3. Push the locking clips out of the locking slots.
4. Loosen and remove any mounting bolts hold-
ing the stack in place.
5. Carefully pull the stack assembly ends apart
and remove the valve block.
6. Replace the valve slice, push the assembly
together and insert the locking clips.
Removing/Adding A Valve Slice
Figure 9: Slice Removal
MCV Color Changer - Maintenance
CS-01-01.8 15
Ransburg