Robinair TIF8800X Combustible Gas Detector - Manual (Page 15)

Symptom Possible Cause Solution
Power indicator LED
does not light; tool is
non-responsive .
1) Battery pack not charged .
2) AC adapter is connected
to tool .
1) Connect AC adapter to tool
and charge battery pack . Refer
to Setup for instructions .
2) Remove AC adapter .
Battery life is less than
3 hours of operation .
1) Battery pack needs to be
conditioned .
1) To condition battery pack:
charge it fully, then operate
tool as normal until the low
battery LED illuminates.
Repeat this procedure a
minimum of 3 to 5 times .
Tool does not operate
and battery pack charge
cycle will not complete
(24+ hour charge applied
and green light does not
illuminate) .
1) Battery pack not
connected .
2) Bad battery pack .
1) Follow instructions in the Setup
section of this manual to check
that the battery pack
connection is secure .
2) Replace battery pack .
Refer to Replacement Parts
section of this manual .
Troubleshooting (continued)