AT&T 1760 - Manual (Page 14)

11
Announcement Monitor
This system comes set to On so you can hear your announcement when the system
answers a call. You can reset the system so you won’t hear the announcement.
1 Press o.
2 Use the softkey to select ANS SYS.
3 Select OK until the screen displays Announce Monitor.
4 Select CHANGE or press C or c to change the setting to On or Off.
5 Select OK.
Caller ID Feature Setup
Turn Caller ID with Call Waiting On or Off
If you don’t want the system to display call information about Call Waiting calls, you can
turn this feature off.
1 Press o.
2 Press C.
3 Use the softkey to select CALL ID. The screen displays Caller ID on Call
Waiting.
4 Select CHANGE or press C or c to turn the feature On or Off.
5 Select OK.
Programming Area Codes
Home and Local Area codes must be programmed into the unit to allow it to properly
recognize and dial calls from the Caller ID call history (when using the Display Dial
feature). By programming these specific area codes, the unit will be able to distinguish a
local call from a long distance call, and will thereby dial the appropriate number of digits.
Home Area Code Guidelines
Most users simply dial the seven digits of a phone number to make a call within their
Home Area Code and 11 digits outside of their Home Area Code. If this applies to you,
you should program your Home Area Code into the unit. After programming, if you
receive a call from within your Home Area Code, the screen will display the seven digits
of the phone number. When you use Display Dial, the unit will know to ignore the
Home Area Code, and dial only the seven digits of the phone number.
SET UP SYSTEM FEATURES
1760_book_1AT&T 5/1/00 7:38 PM Page 11