AT&T 1760 - Manual (Page 23)

20
Ending the Remote Access Call
Press * 9. The system announces,“The machine will now hang up,” and disconnects
from the line.
Changing Remote Access Code
1 Connect with the answering system.
2 Press
9 9. The system announces “Enter new code.”
3 Enter your new Remote Access Code (any number between 000 and 999).
4 If a valid code is entered, the system announces the new Remote Access Code.
If an invalid code is entered, the system beeps five times rapidly, then beeps twice.
Repeat
Steps 2 and 3.
Turn System Off
1 Connect with the answering system.
2 Press
0 0. The system announces,“The machine is off.”
Turn System On
When the system is off, it answers after 10 rings, announces “The machine is off,” and
beeps twice.
1 Connect with the answering system.
2 Press
0 to turn the system on. The system announces,“The machine is on.”
3 The system beeps twice and is ready to answer calls and record messages. If the
system beeps five times, the memory is full.
Memory Full
The system answers after 10 rings, announces “Memory is full,” and beeps twice.
1 Connect with the answering system.
2 Enter your Remote Access Code after the two-beep signal.
3 Listen to messages and delete some or all of them.
4 Press
0 to make sure your system is on before you hang up.
ANSWERING SYSTEM OPERATION
FROM A REMOTE TOUCH TONE PHONE
1760_book_1AT&T 5/1/00 7:38 PM Page 20