Securitron DK-XB - Manual (Page 10)

PN# 500-20300
Page 10 Rev. D, 06/11
PROGRAM RELAY 1 MODE: DOOR PROP
UCD: ANTI-TAILGATING
PROGRAM RELAY 1 MODE: DOOR PROP
The door prop function which includes anti-tailgating and takes over programmable relay #1 is
assigned in these two line messages to the HCD terminal (command 82) or the UCD terminal
(command 83)
HCD: HARD CODE DISABLE
UCD: USER CODE DISABLE
Entry of command 84 will restore either the HCD or UCD terminal to its default function of
disabling codes. One of the two messages shown above will print depending on which terminal
had been previously reassigned to either anti-tailgating or to door prop
D/T DOOR FORCED
This message will appear if door prop or anti-tailgating modes are enabled and the door reports
open without the keypad lock control relay releasing the lock
D/T DOOR PROPPED
This message will appear if door prop or anti-tailgating modes are enabled and the door remains
open after the lock release timer has expired (whether the door was released on entry or REX
exit)
D/T DOOR RESTORED
This message will appear when the door has reclosed following a door forced or door propped
event (see previous two messages)
D/T DURESS
This message appears when a programmable relay operates in duress mode from command 75
(hard code has been entered)
D/T DURESS RESET
This message appears when, in duress mode, the hard code is entered a second time to reset
the programmable relay
PROGRAM RELAY 1 MODE: DURESS
PROGRAM RELAY 2 MODE: DURESS
PROGRAM RELAY 1 MODE: TAMPER
PROGRAM RELAY 2 MODE: TAMPER
PROGRAM RELAY 1 MODE: LIGHT
PROGRAM RELAY 2 MODE: LIGHT
PROGRAM RELAY 1 MODE: DOORBELL
PROGRAM RELAY 2 MODE: DOORBELL
The above eight messages respectively echo the receipt of programming commands which
assign the two programmable relays to any of four functions
UNLOCK TIME = XX SECONDS
This messages echoes any change in the lock release time (default = five seconds)
LOCK RELAY IN TOGGLE MODE
This message confirms putting the lock control relay in toggle mode (command 900)
ALL USER CODES ERASED
This message echoes command 88
ALL FUNCTIONS TO FACTORY PRESET
This message echoes command 89