Securitron EMB_Series - Manual (Page 3)

PN# 500-23130
Page 3 Rev. C, 03/11
Mounting Diagram
Hollow Metal (Aluminum Frame Glass) Door Preparation Shown
* NOTE: Drill holes through mounting side of hollow doors only!
Blind Nut Installation:
 Insert the blind nut of the installation tool into a 3/8” [9.5mm] diameter hole.
 Hold the collapsing nut with a 1/2” box end wrench.
 While maintaining pressure toward the mounting surface, use a 3/16” hex wrench to tighten
the cap screw and collapse the blind nut.
 Once the blind nut is firmly collapsed, remove the tool by unthreading the cap screw from the
installed nut.
 Place another blind nut onto the installation tool and install remaining blind nuts using the
same procedure.
Hinge Side
of Door