Securitron EMB_Series - Manual (Page 5)

PN# 500-23130
Page 5 Rev. C, 03/11
5.1 WIRE ROUTING THROUGH END CAP (OPTIONAL)
Drill End Cap:
 Determine which bar end cap to
feed the flexible door cord shield
into. Normally the bar wire cable
and door cord shield go to the
hinge side of door.
 Mark and/or center punch the
bottom side of the chosen end
cap at the location shown.
 Drill a 3/8” [9.5mm] diameter
hole through the wall of the end
cap.
Install Cord Shield to Cap:
 Insert the door cord shield
through the hole drilled in the
end cap.
 Secure cord shield in place
through the hole using two (2)
provided E-clips. (One to the
inside and one to the outside of
the cap).
 Install a door cord insert into
each end of the door cord shield.
 Route bar wire cable through the
cord shield.
 Install the end cap to the end of
the bar.
Install Cord Shield to Frame:
 Drill a 3/8” [9.5mm] diameter hole into the door frame at the desired position adjacent to bar
end mount.
 Position door cord cap to fully cover the 3/8” [9.5mm] diameter hole, and then mark the two
(2) mounting holes.
 Drill two (2) 1/8” [3.2mm] holes at the marked locations.
 Install door cord insert over end of bar wire cable and slide up and into the loose end of the
flexible door cord shield.
 Route wire cable through hole in frame and make electrical connections.
 Insert the end of the door cord shield into the cord cap. Ensure that the spiral grooves of the
cord shield are engaged by the teeth inside the cord cap.
 Install the door cord cap over the wire cable and door cord shield, and then secure into place
using the two (2) provided #6 screws.
OR
Install Door
Cord Insert
Here
2X #6 Mounting
Screws
Door Cord
Cap
3/8” [9.5]
Diameter Hole
2X 1/8” [3.2]
Diameter Hole
Door Cord
Insert
Right End Cap
(Bottom)
Left End Cap
(Bottom)