Audiovox afx-35 - Manual (Page 22)

Window Messages
During sending, the window will display a message
similar to the one below to inform you of its status
or activity.
In this example, the number in the top of the
window is the telephone number of the receiving
fax. SEND’ means you are sending, "G3" indicates
the communications standard observed by both fax
machines, ‘9.6’ indicates the transmission speed
(9600 bps), and the number following ‘P:’ is the
number of the page being sent. If a fax transmission
fails or the unit detects a problem, it may display an
error message in the window. Refer to “Error
Messages” on page 28 to clear the problem and try
to send the document again.
Clearing Document Jams
If the fax unit starts to read the document and for
some reasons, stops without reading all of it, the
document might be jammed. The unit displays
‘DOCUMENT JAM’. DO NOT pull it out of the
loading. To clear the jam, open the control panel
using hand as shown below.
It will release the grip on the document. Wait until
the white roller in the unit stops moving. You can
then remove the jammed document without
damaging
your unit. Close the cover. ‘DOCUMENT
JAM’ message disappears and the unit returns to
the standby mode.
Note: If the roller doesn’t stop moving, lift the edge
of the document and pull it in the direction of arrow.
Important Sending Facts
continued
Printing Information on Sent
Pages
you have entered a Terminal ID message (see
your fax number and name along with
date, time, and page number will appear at the
of each page at the receiving end.
setting one of User Options, you can choose
to print this information directly over
is at the top of each page, or not.
21
TEL:51