Securitron EPT_EPTL - Manual (Page 3)

PN# 500-14250
Page 3 Rev. , 04/11
The illustration of Figure 3 represents the configurations for both the solid core wood door and
metal door installations. This is to help to understand the process for flush mounting the
EPT/EPTL in the correct manner for the door application required.
(6)
6-32 x 3/8" Type "F"
Self Tapping Screw
(2)
Flush Tab Bracket
(4)
#6 x 5/8" SMS Screw
(1)
Lead Cover
(1)
Lead Cover
Metal Door
Installation
Wood Door
Installation
.7
00 [17
.8
]
R0.50 [12,7] x
.075 [1,9]
Deep Recess
Flange Area
Square Corner
or
Radius Corner
Countersink for
#6 Flathead Screw
Figure 3
Note: Routing is generally performed into the edge of the door (as shown)
but this can be reversed with the routing being done into the frame.
EPT/EPTL Special UL / Electrical Note:
• To maintain this product’s compliance with UL listings (UL 10C and UBC 7-2-1997), the
maximum number of electrical conductors to be used is twelve (12) - using No. 20-22 AWG size
wire.
• Electrical rating for the EPT and EPTL is 1Amp @ 12V or 24V – AC or DC.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
EL-EPT / EL-EPTL
ElectroLynx VERSION
1. DESCRIPTION
ElectroLynx is a standardized plug-in connection system which allows for the easy installation of
door mounted hardware. Door mounted locking hardware, doors, hinges or power transfer
devices and frames are available pre-wired from ASSA Abloy companies with universal plug-in
connectors for a simplified, time saving field installation.
2. OVERVIEW
The structural design of the ElectroLynx version is the same as the EPT/EPTL unit. It includes an
additional 12 conductor cable placed in the Flexible Coil with 2 connectors applied on each end
containing an 8 pin and a 4 pin connector pre-wired pin-to-pin.
3. PHYSICAL INSTALLATION
The installation of the ElectroLynx Version (EL) is similar to the standard EPT/EPTL. The
ElectroLynx Version comes pre-harnessed on both ends with dual harness plug adapters for
system accessories as illustrated in Figure 4. The dual harness connectors provided come out of
the back side of the Lead Cover for connection to the door edge accessory devices. The opposite
end also contains dual harness plug adapters to connect into device signal lines through the door
frame accessory devices.