Securitron EPT_EPTL - Manual (Page 4)

PN# 500-14250
Page 4 Rev. , 04/11
Attach all proper connections of the harness at the door location. Push the cable and connectors
back into the hole of the door. Mount the Flexible Shield to the Lead Cover as shown in Figure 4.
Mount the Lead Cover as described in Figure 3 and Figure 4. Attach the proper connections at
the frame location. Push the cable and connectors back into the frame. Mount the Flexible Shield
to the frame as described in Section 3 and the EL-EPT/ EL-EPTL Physical Installation in Figure 4.
Note: The frame side of the Flexible Shield also contains a Bezel Plate over the
extended spring section for concealing the oversize hole once mounted to the frame.
11/16" [17,5mm]
Diameter
C
L
3/4" [19,0mm]
Diameter
THESE TWO
CENTERLINES
MUST ALIGN
WHEN THE DOOR
IS CLOSED!
Center Butt Hinge
Cutout Area of Door
Pre-Assembled
Bezel Plate
(Installation Hardware)
Flexible Shield
(ElectroLynx)
EL-EPT
EL-EPTL
Flexible Shield
EPT
EPTL
Bezel Plate
(Installation Hardware)
CL
CL
CL
7.
80
[
198
,1
]
/
1
6
.3
0
[4
1
4
,0
]
Dimensions in [Brackets] are metric (millimeter)
Figure 4
EL-EPT/EL-EPTL ElectroLynx Electrical Note:
Electrical Rating: EL-EPT and EL-EPTL is 1 Amp @ 12V or 24V – AC or DC