SecurityMan Air-AlArm1 - User manual - Manual (Page 13)

10
functions/features:
Mainly detect open/close states of doors and windows, generally set as a 1st Defense Line or perimeters. •
If any doors or windows are opened, it will transmit the alarm signal to notify the alarm host. •
specifications:
Operating power: 23A or 27A 12V Battery (Recommend: alkaline battery) •
Wireless Transmitting distance: ≥450ft (in open area) •
Service life: ≤2 years •
Alarm Distance: <4cm •
installation and Usage
Mount the magnet or smaller piece onto the door in a position of about 5~6ft above the ground to prevent any child(ren) from tampering. •
Use the included mounting bracket if the door and the door frame are un-even or not flush.
Mount the emitting or larger piece onto the door frame, ensure the magnet piece and the emitting piece are even or flush. The spaces
•
between the two should be less than 10mm in gap.
Replace the battery if the red LED light flashes frequently.
•
Adding and Cancelling Door/Window sensor
To Add:
Press_ • set + Password + eNT_then.
_ • 70 + eNt+ XX + eNt The “Learn” light will appear solid red.
Note: the “XX” indicate group number of the 1st defense zones, including zone 06 through zone 10.
Triggers the Door/Window magnet twice consecutively, the alarm host will beep in series and the “Learn” light flashes five times and then •
turns off to indicate the magent door/ window sensor has been successfully added.
To Cancel:
Press_ • set + Password + eNt_then.
_ • 71 + eNt+ XX + eNt The alarm host will beep twice then the “Learn” light will flash once and then turns off to indicate the
magnet door/ window sensor has been successfully cancelled.
Note: the alarm host can only learn 1 wireless device (magnet Door/Window sensor) at a time, a total of 4 wireless devices (magnetic
sensors) to a zone/group can be added. for example; for the 1st defense line, if 4 sensors were to be added to zone/group 06 through
zone/group 10, it total 20 sensors in all. if 1 device is removed from a group that has 4 devices, then all 4 devices in the group will be
automatically removed, and each device(s) will have to be added again to the alarm host.