Gilderfluke&Co old MACs 8 bit Digital Audio System - Manual (Page 34)

- MIX BUS Feed from Pri Mix Point (ÔPRI MIX FEEDÕ card installed) -
DIGITAL
AUDIO
REPEATER
VOLTAGE
CONTROLED
AMPLIFIER
PUBLIC
ADDRESS
SYSTEM
OPTO
ISOLATION
35Khz
LOWPASS
FILTER
SHELVING
EQUALIZER
OUTPUT
DRIVERS
PA AUDIO & CONTROL SIGNALS
FROM MA-100 MASTER
GLOBAL/MIX BUS #1
GLOBAL/MIX BUS #2
GLOBAL/MIX BUS #3
GLOBAL/MIX BUS #4
AUXILIARY INPUT
EXTERNAL MIX INPUT 'A'
EXTERNAL MIX INPUT 'B'
VCA BUS
VCA IN/OUT
VOLUME
1/2
MUTE
(or Optional
High or Low
Pass Filters)
OUT
ISOLATED
POWER SUPPLY
PA
VOLUME
BASS TREB.
10v REF.
START & STATUS
ÔPRI MIX FEED': When you want to feed the audio signals from this cardÕs primary mix point to feed
the MIX BUS. The primary mix point is ÔupstreamÕ of the VCA, PA, and all other audio processing,
so it will be the ÔrawÕ audio data which will be fed to the bus. You must also turn on one, and
only one of the ÔMIX BUSÕ switches. This configuration card is used when you want to feed the
audio from this card, along with the audio from any number of other cards, to one other card
in the system (the card which will listen to the mix bus must be configured with the ÔMIX LISTENÕ
configuration card and the same ÔMIX BUSÕ switch turned on as on this card).
The ÔBUS FEEDÕ pot on the front panel of the DR- Repeater card you are configuring
controls how ÔhotÕ a signal is sent to the MIX BUS from this card. By adjusting the ÔBUS FEEDÕ pot
levels of all of the cards feeding this MIX BUS, the relative volumes of all of the signals feeding
this MIX BUS can be adjusted.
G ILDERFLUKE & C o . ¥ 205 S OUTH F LOWER S T . ¥ B URBANK , C ALIF . 91502-2102 ¥ 818/840-9484 ¥ FAX 818/840-9485
24