Gillette Generators SPP-180 - Manual (Page 17)

PAGE 17
Dielectric grease should be used on battery lugs or
posts to help in the prevention of normal corrosion.
Damage will result to generator controls, if battery
cables are made in reverse connections.
Inspect, clean, or re-grease battery connections ever
60-90 days.
In cold climate areas, where temperatures normally
reach 10º F (-12º C) or colder, a battery wrap-around
heater, controlled by thermostat, should be used, for
increased battery power.
This generator is equipped with an automatic “float
type” battery trickle charger, energized by utility
power, to maintain full battery power while on
standby (non-running) condition. CAUTION: This
trickle charger can not recharge a fully discharged or
defective battery.
● Do not dispose of battery in a fire. The
battery is capable of exploding and
spewing electrolyte in several directions.
● Do not open up a battery. It has
electrolyte and is harmful to the skin and
eyes, and is toxic.
● Battery
electrolyte is electrically
conductive and corrosive.
● Contact with battery acid will cause
severe burns to the skin and eyes.
A battery can cause an electrical shock. Before
working on a battery, follow safe procedures:
● Remove the start/stop 20 amp fuse in control
circuit.
● Remove all rings, watches, & other metal objects.
● Wear rubber gloves and boots.
● Use tools with insulated handles.
● Do not lay tools or metal objects on top of battery.
● Disconnect the battery charger before working on
battery terminals.
A battery can cause a chemical burn. Before working
on a battery, follow safe procedures:
● Wear full eye protection and protective clothing.
● When battery electrolyte contacts the skin, wash it
off immediately with water.
● When battery electrolyte contacts the eyes, flush
immediately and repeatedly with water and seek
medical help.
● Spilled electrolyte should be washed away with an
acid neutralizing product.
● A battery can cause fire or explosion because they
emit hydrogen gas.
● Do not smoke or cause any type of flame within 30
feet from battery.
● Discharge body static electricity from body, by
touching a grounded metal surface, before working
on battery.
Before checking oil, always move controller selector
switch to “OFF/RESET” position, and remove 20 amp
fuse.
1) Oil Considerations: Check the oil to make sure it’s
at the proper level. Remove the oil dipstick, wipe it
clean, re-install oil dipstick, then remove it again to
check the oil level. See diagram on page 18.
Crankcase pressure can blow hot engine oil out the
fill opening, causing severe burns. Always stop the
gen-set before removing oil dipstick or oil fill cap.
Use API SJ 10W-30 oil for temperatures above 32º F
(0º C). All gen-sets are shipped with this grade oil.
WARNING
DANGER
BATTERIES CAN CAUSE
DANGEROUS CHEMICAL BURNS
FINAL PREPARATIONS BEFORE
INITIAL START-UP
BATTERIES CAN CAUSE FIRE OR
EXPLOSION
BEFORE WORKING ON BATTERY:
● Always remove 20 amp fuse in control panel.
● Always turn the “auto-off-manual” switch to off
position.
BATTERIES CAN CAUSE
DANGEROUS ELECTRICAL SHOCK
NOTICE