Harwin C90 Braid Adaptors - Tie-Band - Manual (Page 4)

IS-33 Issue: 2 Date: 28.04.11 C/Note: 11256 Page 4 of 4
10. To loosen or remove clamp after tension handle locks against tool body, squeeze ten-
sion handle and push tension release lever forward. Let tension handle return to its
original position, then use gripper release lever and pull band out. (Fig 5) Completed
clamp (Fig 6) may be covered with shrink wrap or tape for protection.
Fig 5 Fig 6
Fig 7
Correctly installed clamp must
Have full locking lip on all
Tie-Dex and Tie-Dex Microbands.
If lip is damaged or missing,
Re-calibrate tool tension, check
Condition of cutter blade and
Knife, replace if worn or damaged.
Slip cutters under buckle and cut one side of buckle
On line shown in figure below.
Peel buckle open to free lip lock.
Cut buckle on line
Completed clamp
Cutters
Completed Tie-Dex
Harwin North America Harwin Europe Harwin Asia
T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 386
E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com.sg
11. To remove completed clamp see (Fig 7). See http://www.band-it-idex.com/en/
products/Tools/Tie-Dex%20II%20Tool.html
and select tool A490 for full tooling instruc-
tions.