On-line mode – IDEC DATAVS2 Series User Manual

Page 26

Advertising
background image

SVS2

Series

Instruction

Manual

21

6.2.2. On-Line Mode


Here you need to select the sensor you wish to connect to.
When you select this mode, you will be asked to set connection mode. You may connect to an IP
address stored previously or run a new search.


When you press the Find SVS button, the system searches for connected sensors in the network and
displays their network addresses (IP and Subnet Mask address) and an icon indicates whether they
are accessible using this information. After the desired sensor is added to list, if the icon is as shown in
the figure, tick the box on the right end and click Connect to establish the connection.

You may also configure the selected connection (click “Configure”).

Advertising