Foredom Series H - Manual (Page 5)

4
Specifications
Series H Ball Bearing Universal Motor:
115 Volts 3.0 Amps 50/60Hz Operable Speed Range 0-20,000 RPM
230 Volts 1.5 Amps 50/60Hz Operable Speed Range 0-20,000 RPM
SCH Control:
Variable speed, foot operated electronic control in metal housing for use only
with Series H Motors. (AC only.) SCH-1 is for use with 115 Volt Series H motors;
SCH-2 is for use with 230 Volt Series H motors.
FCH Control:
Variable speed, foot operated electronic control in heavy duty plastic housing for
use only with Series H Motors. (AC only.) FCH-1 is for use with 115 Volt Series
H motors; FCH-2 is for use with 230 Volt Series H motors.
EMH Control:
Variable speed, manually operated electronic control in plastic housing, for use
with Series H Motors only. (AC only.) EMH-1 is for use with Series H 115 Volt
motors; EMH-2 is for use with Series H 230 Volt motors.
Shaft/Sheath Assembly consists of the following:
Flexible Shaft (10805): 46 inches long, .187
″ diameter square drive.
Flexible Sheath (10802A): Heavy duty
Silencer (10822)
Complete Assembly (10804B)
Handpieces
The 44HT, 30H and 25H handpieces, shown below, are for use exclusively with
Series H, HB and HM motors.
44HT – Collet-type, ball bearing handpiece. 1-inch diameter, 6 1 ⁄
4
″ long. Supplied
with 1/8
″ and 1/4″ collets, pin and wrench. Additional collets are available sepa-
rately. Collet Set 440 consists of 7 collets in sizes ranging from 1/16
″ to 1/4″.
Metric collets in 3mm and 6mm are also available.
30H – Chuck-type, ball bearing handpiece. 1-inch diameter, 5 3 ⁄
4
″ long.
Accommodates accessory shanks up to 5/32
″. Supplied with a CK-0 chuck key
in plastic handle.
25H – Heavy duty, precision ball bearing handpiece. 1 1 ⁄
32
″ diameter, 6
1 ⁄
8
″ long.
Supplied with 1/8
″ and 1/4″ collets, pin and wrench. Additional collets are avail-
able separately. Collet Set 103000 consists of 5 collets in sizes ranging from 1/ 16
″
to 1/ 4
″. Metric collets in 3mm, 4mm, and 6mm are also available.