Inter-M PAM-520 - Manual (Page 13)

10 PAM-510/520
ATT. ZONE AMPLIFIER
Application of the Antenna Application of the Antenna
- FM RECEIVING ANTENNA
The electric wave of FM broadcasting is weakening in hills and valleys, around buildings and in iron-
reinforced buildings.
- INSTALLATION OF ANTENNA EXCLUSIVELY FOR FM
Listening to the broadcasting, fix the antenna after deciding the location and the direction so that the reception
may be optimized.
- INSTALLATION OF ANTENNA USING THE COAXIAL CABLE
Noisy reception may occur in built-up areas and factory sites as well as around power cables. This may be the
case even when an antenna is used exclusively for FM. In these regions, install the antenna using 75
Ω coaxial cable.
- INDOOR ANTENNA
In the regions where FM broadcasting is heard comparatively well due to the near distance to the station or
wooden structure, you can receive broadcasting of good quality by using T-type antenna.(using matching
trans:300
Ω/75Ω)
- AM LEAD ANTENNA
Fix one end of a six to eight metre length of vinyl-coated single cable to the AM terminal and the other end to
a high place like a wall.
- AM OUTDOOR ANTENNA
Install the vinyl-coated cable to an outdoor place if the AM reception is not good enough.
- AM LOOP ANTENNA
Connecting the feeder of the loop antenna of the terminal of 300 Ω.
Listening to the broadcasting, fix it after deciding the location and the direction so that the receipt condition
may be optimum.