JuiceGoose CQ Series - Power Sequencers - Manual (Page 5)

INSTALLATION
CQ 1520 — Mount the CQ-1520 to a 19” wide rack with metal mounting rails,
designed with 1.75” spacing. Use appropriate rack mounting hardware. Plug
the power cord into a grounded outlet. Do not defeat the grounding feature
of the CQ-1520 power cord.
CQ 1, 2200, 3000 & CQ-PD1-4 - These products were designed to be installed
only by qualified electrical technicians. Failure to follow correct installation
techniques and instructions could result in equipment damage and/or personal
injury.
CQ 1 - This product should be installed in a three gang utility box mounted
inside a wall. The installation process may vary depending on whether the
installation is in new or retrofit construction. Fit the utility box into the space
where the CQ 1 will be installed.
CAUTION: Be certain power has been turned off at the breaker panel or dis-
connected before installation.
(ATTENTION: certains power a été désac-
tivé sur le panneau de disjoncteur ou déconnecté avant l'installation.)
Pull the main power cable and the RJ45 signal cable(s) into position inside the
utility box. Connect the power feed to the corresponding colored wires on the
CQ 1 using wire nuts or another acceptable method. Plug the input signal ca-
ble into the Input port on the CQ1 and the output cable into the Output port.
Install the CQ 1 enclosure and cover plate onto the utility box with the screws
provided with the unit.
CQ 2200 & 3000 are intended to be hardwired to a main utility power supply
with power cable routed through conduit. A “squeeze” type conduit connector
is assembled onto the CQ back box specifically for this purpose. A power line
strain relief is also included in the box with the CQ device in case alternate
power connection is necessary.
These two CQ Series models have front panel and a back box construction
that are held together with seven screws. To begin installation, remove the
screws that hold these two pieces together. The back box has four holes in
the back surface. These holes are large enough to accommodate mounting
screws or bolts (not included) to hold the CQ device securely to a stable, flat
mounting surface, such as a wall. At least two screws or bolts should be used
to mount the back box.
CAUTION: Be certain power has been turned off at the breaker panel or dis-
connected before installation. (
ATTENTION: certains power a été désac-
tivé sur le panneau de disjoncteur ou déconnecté avant l'installation.)
After the back box is secured, feed the cable that is connected to the desired
power source through the hole in the side of the back box. Securely crimp a
connector (provided) to the end of each wire lead (hot, neutral and ground).
Press the connectors onto the appropriate locations on the circuit board as