LevelOne PLI-4510 - Manual (Page 20)

18
following information is displayed for all devices that appear in the lower panel.
Device Name column shows the default device name, which may be user re-defined. A user can
change the name by either using the rename button or by clicking on the name and editing in-place.
An icon is usually shown with the name. By default, the icon is always accompanied by a device
name.
MAC Address column shows the Remote device’s MAC address.
Password column by default is blank and ‘Enter Password’ button can be used to enter it.
To set the Password of the device (required when creating a private network), first select the device
by clicking on its name in the lower panel and then click on the Enter Password button. A dialog box
will appear as shown in Figure 3-3 to type the password. The selected device name is shown above
the password field and the password can be verified by hitting the OK button. The Password field
accepts the Device password in any case formats, with or without dashed between them. If a device
was not found, the user will be notified along with the suggestions to resolve common problems. This
process might take a few seconds to get completed.
Figure 3-3: Set Device Password