LevelOne PLI-4510 - Manual (Page 21)

19
Add button is used to add a remote device to the existing network by entering the device password
of the device. A dialog box will appear as shown below in Figure 3-4. The dialog box allows the user
to enter both a device name and the password. If a device was not found, the user will be notified
and suggestions to resolve common problems will be presented.
Figure 3-4: Add Remote Device
Note: The device must be present on the power line (plugged in) in order for the password to be
confirmed and added to the network. If the device could not be located, a warning message will be
shown.