LevelOne KVM-0410 - Manual (Page 10)

LevelOne
17
next computer in sequence. The length of the Auto Scan interval
(Scan Rate) is adjustable. To abort the Auto Scan mode, press the
left Ctrl key twice.
Note: Scan Type determines whether an eye-marked computer is
to be displayed during Auto Scan.
% Manual Scan enables you to manually switch back and forth
between power-on computers.
Left Ctrl + left Ctrl + F2
Press ↑ or ↓ to select the previous or the next computer in
sequence. And, press any other key to abort the Manual Scan.
Note: Scan Type determines whether an eye-marked computer is
to be displayed during Auto Scan.
% To adjust Scan Rate which sets the duration before switching to the
next computer in Auto Scan:
Left Ctrl + left Ctrl + F3
The KVM switch beeps one to four times indicating the scan interval
of 3, 8, 15 and 30 seconds respectively..
% To adjust keyboard typematic rate (characters/sec), this setting
over-rides that of BIOS and any operating system:
Left Ctrl + left Ctrl + F4
The KVM switch beeps 1 to 4 times corresponding to 10, 15, 20 and
30 characters/sec respectively.
% Audio Stick
An optional multimedia module can be LINKed to the back of each
KVM switch for selecting microphone and stereo speaker signals.
There are two options for Audio Stick: ON and Off. When set to
'On', audio selection follows computer selection. When set to 'Off',
audio selection stops following computer selection. It is useful if
you want to listen to a particular computer's audio signal while
operating other computers.
Left Ctrl + left Ctrl + F5
The KVM switch beeps once or twice corresponding to On and Off
respectively.
LevelOne
18