LevelOne KVM-0410 - Manual (Page 8)

LevelOne
13
<ENTER>. Available options will be shown in the middle of the
screen. Again, using the <UP> and <DOWN> arrow keys to
view options then press <ENTER> to select it. You can press
<ESCAPE> to exit at any time.
!
Auto Scan
In this mode, the KVM switch automatically switches from
one power-on computer to the next sequentially in a fixed
interval. During Auto Scan mode, the OSD displays the
name of the selected computer. When Auto Scan
detects any keyboard or mouse activity, it suspends the
scanning till activity stops; it then resumes with the next
computer in sequence. To abort the Auto Scan mode,
press the left <CTRL> twice, or, press any front button.
Scan Type and Scan Rate set the scan pattern. Scan
Type (<F4>:More\Scan Type) determines if scanned
computers must also be eye mark selected. Scan Rate
(<F4>:More\Scan Rate) sets the display interval when a
computer is selected before selecting the next one.
!
Manual Scan
Scan through power-on computers one by one by
keyboard control. You can type (<F4>:More\Scan Type) to
determine if scanned computers must also be eye mark
selected. Press the up arrow key ( ↑) to select the
previous computer and the down arrow key (↓) to select
the next computer. Press any other key to abort the
Manual Scan mode
!
Audio Stick
An optional multimedia module can be LINKed to the
back of each KVM Switch for selecting microphone and
stereo speaker signals. There are two options for Audio
Stick: ON and Off. When set to 'On', audio selection
follows computer selection. When set to 'Off', audio
selection stops following computer selection. It is useful
if you want to listen to a particular computer's audio signal
while operating other computers. The non-volatile
memory stores the Audio Stick setting.
LevelOne
14
!
Scan Type
Ready PC +
" : In Scan mode, scan through power-on
and eye mark selected computers.
Ready PC: In Scan mode, scan through power-on
computers.
" Only : In Scan mode, scan through any " selected
computer regardless of computer power status. This
option is not available for 4-port models.
The non-volatile memory stores the Scan Type setting.
!
Scan Rate
Sets the duration of a computer displayed in Auto Scan
mode. The options are 3 seconds, 8 seconds, 15
seconds and 30 seconds. The non-volatile memory
stores the Scan Rate setting.
!
Keyboard Speed
LevelOne KVM switch offers keyboard typematic setting
that overrides the similar settings in BIOS and in Windows.
Available speed options are Low, Middle, Fast and
Faster as 10, 15, 20 and 30 characters/sec respectively.
The non-volatile memory stores the Keyboard Speed
setting.
!
Hotkey Menu
When you hit the left <CTRL> key twice within two
seconds, the "Hotkey Menu" appears displaying a list of
hotkey commands if the option is On. The 'Hotkey Menu'
can be turned Off if you prefer not to see it when the left
<CTRL> key is hit twice. The non-volatile memory stores
the Hotkey Menu setting.
!
CH Display
Auto Off: After you select a computer, the port number
and name of the computer will appear on the screen for 3
seconds then disappear automatically. Always On: The
port number and name of a selected computer and/or
OSD status displayed on the screen all the time. The