LevelOne KVM-0410 - Manual (Page 6)

LevelOne
9
------------------------ Operation
Figure 7: Front pushbuttons and LEDs
Pushbuttons
A computer may be selected by pressing the pushbutton directly, by
issuing hotkey commands or by activating the OSD window.
Note: For 16-port models: 1 ~ 8 represent the lower 8 ports and A ~
H for the higher 8 ports. To select computer A, press and hold
pushbutton 1 for 2 seconds; for computer B, press and hold
pushbutton 2, etc.
! K/M RESET
K/M RESET solves most problems developed by keyboard, mouse,
device replacement or change of configuration. Press down both the
front-panel number 1 and 2 pushbuttons for 2 seconds to re-configure
the whole system without turning either the KVM Switch or any
computer off.
! AUTO SCAN
LevelOne KVM Switch provides an easy-to-use feature to start Auto
Scanning. For 8 and 16-port, you can press down both the front-panel
number 7 and 8 pushbuttons for 2 seconds to start Auto Scanning.
And for 4-port KVM, you can press down both number 3 and 4 to start
Auto Scanning.
LEDs
The lighting red LED indicates the port that is selected. The port is
LevelOne
10
either Auto Scan or Manual Scan mode if the red LED flashes.
Green LED is lighting when the port connects a power-on computer
.
There are 2 rows of LEDs for 16-port switches, the lower row is for
numerical ports (“1” ~ “8”) and the upper row is for alphabetical ports
(“A” ~ “B”).
OSD (On-Screen-Display) Operation
Figure 8: OSD screen illustration
USB-PS/2 Combo models offer F5, see Function key <F5>
By hitting the left <CTRL> key twice within two seconds, you may see
the 'Hotkey Menu' if it is enabled (an OSD option). Or, by hitting the
left <CTRL> key three times within two seconds, you will see a 'KVM
MENU' screen showing a list of the computers with corresponding