Steelcraft Automotive 72250 BULL BAR - Manual (Page 3)

BULL BAR
09-13 DODGE RAM 1500
Page 3 of 5 6/6/13 Rev4(DP)
Driver Side Installation Pictured
Fig 1B
Pin
Housing
IMPORTANT: On models without tow
hooks, use only the supplied
12-1.5mm x 30mm Fine Thread Hex Bolt
12mm Flat Washer
12mm Lock Washer
Frame Mounting Bracket
"No Tow Hook Models,"
use factory hex nuts
Pry up the center pin to
remove the complete fastener
(Fig 1A) Pictured from behind bumper
(Fig 2) Driver side pictured from behind
bumper (non tow hook models)
Front
Remove the (2) factory hex nuts
from the lower bumper bolts
(Fig 3) Driver side Support Bracket
in "no Tow Hook" position
Front
(1) 10mm x 35mm Hex
Bolt
(2) 10mm Flat Washers
(1) 10mm Lock Washer
(1) 10mm Hex Nut
Driver side Mounting
Bracket requires:
(2) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
Front
Fig 4