Steelcraft Automotive 72250 BULL BAR - Manual (Page 5)

BULL BAR
09-13 DODGE RAM 1500
Page 5 of 5 6/6/13 Rev4(DP)
Driver Side Installation Pictured
Installation Complete
Measure the distance from the mounting point
for the splash guard to the bracket on the driver
and passenger side. Use this measurement as a
reference point to check location before cutting
the 1/2" wide x 4" long slot
Cut only what is needed to insert bracket
through the splash guard. Do not cut
through the front edge of the splash guard
Installation pictured without the
splash guard for illustration
Hole for mounting bolt
If required, replace the rivet at the corner
of the splash guard with the supplied:
5mm x 15mm Button Head Allen Bolt
(2) 5mm Flat Washers
5mm Nylon Lock Nut
Front
Front
Fig 9
Fig 10
Fig 11