Acer Altos G520 series - Manual (Page 159)

149
Configuring the onboard SATA
RAID
This section briefly shows how to create RAID 1 (mirror) volume with
onboard SATA RAID function.
How to enable the onboard SATA RAID
function
Load BIOS default setting
1 Power on the server to start the system POST (Power On Self Test)
process. During bootup, press <F2> to enter the BIOS setup screen.
2 Press <F9> to load BIOS default setting and press <F10> save the
configuration changes and exit setup.
Enable onboard SATA RAID function
1 In the BIOS Setup Utility, move cursor to <Advanced>. Then select
<IDE Configuration> and press Enter.
2 Move cursor to Configure S-ATA as RAID and press Enter to change
the Options to [Enabled].
3 Press <F10> save the configuration changes and exit setup.
How to create RAID 1 volume
Enter the onboard SATA RAID Configuration Utility
When you see the Intel Embedded Server RAID information shows on
the screen during the POST (Power-On Self Test), press <Ctrl> + <E> to
enter the Embedded RAID Configuration Utility.
Loading onboard SATA RAID default setting
1 Select Objects from Management menu.
2 Select Adapter from Objects. The selectable adapter will be listed.
3 Press Enter on the adapter and the adapter setting will be shown
on the screen. You can change the setting from this menu.
BB!H631!.!FO/cppl!!Qbhf!25:!!Uvftebz-!Bvhvtu!28-!3115!!5;13!QN