Configuring the non-hot plug hdd cage, To remove the cage – Acer Altos G520 series User Manual
Page 59
Advertising
49
Configuring the non-Hot Plug HDD
cage
This section includes instructions for removing and installing the non-
Hot Plug HDD cage as well as procedures on how to install a hard disk
into the cage.
To remove the cage
1
Turn off the system and all the peripherals connected to it.
2
Unplug all cables from the power outlets.
3
Place the system on a flat, stable surface.
4
Remove the front bezel, inner front panel, side panel, and air
baffle.
5
Disconnect the HDD bus cable and the HDD power cable from the
hard disk drive.
6
Loosen the four thumbscrews that secure the cage to the chassis
(1).
7
Removet the cage from the chassis (2).
BB!H631!.!FO/cppl!!Qbhf!5:!!Uvftebz-!Bvhvtu!28-!3115!!5;13!QN
Advertising