Teledyne LeCroy WS-GPIB - Manual (Page 4)

Safety Information
This symbol may appear on the product:
This refers you to additional information contained in the operator’s manual.
The corresponding information in this manual is similarly denoted.
To avoid personal injury or damage to the WS-GPIB or any equipment
connected to it, review and comply with the following safety precautions.
Use only as intended.
The WS-GPIB is intended to be used only with the LeCroy WaveSurfer series
oscilloscopes. Do not connect the USB connector of the WS-GPIB to any
device other than a WaveSurfer oscilloscope.
Use of the WS-GPIB and/or the equipment it is connected to in a manner not
specified by the manufacturer(s) may impair the protection mechanisms.
Connect and disconnect properly.
Do not connect or disconnect equipment to the GPIB connector of the WS-GPIB
while the equipment power is on.
Do not disconnect equipment when red LED is ON. The red LED of the
WS-GPIB lights up while the communication is in progress.
Disconnecting equipment during this time may result in data corruption or
equipment damage.
Do not use in wet/damp or explosive atmospheres.
For indoor use only.
The WS-GPIB is intended for indoor use and should be operated in a clean, dry,
environment.
Do not operate with suspected failures.
Do not use WS-GPIB if any part is damaged. All maintenance should be
referred to qualified service personnel.
Keep product surfaces clean and dry.
Cleaning
The outside of the WS-GPIB should be cleaned with a soft cloth dampened with
either deionized / distilled water or isopropyl alcohol. Allow the surface to dry
completely before returning the instrument to service.