Teledyne LeCroy WS-GPIB - Manual (Page 7)

„ Overview
Connecting the WaveSurfer and a PC equipped with a GP-IB interface
using the WS-GPIB allows you to control the WaveSurfer via the GP-IB.
The GP-IB connector conforms to IEEE488.2 standard. Its delimiter
setting is LF+EOI. The USB connector conforms to USB 2.0.
For details of the GP-IB commands, see the Remote Control Manual in
the User's Manual CD supplied with the WaveSurfer.
Note that the WS-GPIB does not functions as a controller.
Make sure to thoroughly read this manual and have a good understanding
of the GP-IB prior to using it.
„ How to Use the WS-GPIB
Use the WS-GPIB following the steps shown below.
(a) Connection
As shown in Figure 1 below, connect the USB connector of the
WS-GPIB to the USB port of the WaveSurfer, then connect the other end,
the GP-IB connector, to that of the PC.
NOTE: During this operation, keep the power button of the
WaveSurfer,the PC in the OFF state.
WS-GPIB
Figure 1 Connection Diagram of GP-IB Control
GP-IB
connector
USB port
Desktop or
notebook PC
ＷaveSurfer