Teledyne LeCroy WaveRunner Automation Command - Manual (Page 101)

Automation Command and Query Reference Manual - Control Reference
Setup Action
After the Telecom Standard has been choosed, the Source set, the 'Setup' command will perform all
acquisition setup, make the appropriate alignments and make test ready to run.
This is one of the action to control the state machine of Mask Testing : Setup, ReAlign, Stop, Pause,
Run and VerticalAlign.
Description
' Visual Basic Script
Set app = CreateObject("LeCroy.WaveMasterApplication.1")
'Select an stadard and run the test
app.ElectricalTelecom.Standard = "E1Coax"
app.ElectricalTelecom.Setup
app.ElectricalTelecom.Run
app.Sleep 5000
app.ElectricalTelecom.Pause 'pause the test after 5 seconds
Example
Source Enum
Specify on which channel (C1 to C4) the electrical signal to be tested is connected.
Description
' Visual Basic Script
Set app = CreateObject("LeCroy.WaveMasterApplication.1")
'Select an stadard and the source
app.ElectricalTelecom.Standard = "E1Coax"
app.ElectricalTelecom.Source = "C4"
app.ElectricalTelecom.Setup
Example
Values
C1
C2
C3
C4
1-93
918500 RevA