Teledyne LeCroy QPHY-PCIe3-Tx-Rx - Manual (Page 14)

10 923662 Rev B
Edit Variables
The Variable Setup tab contains a list of test variables. See QPHY-PCIE3-TxRx Variables for a
description of each.
To modify a variable:
1. Select the variable on the Variable Setup tab, then click Edit Variable. (You can also
choose to Reset to Default at any time.)
Note: Especially check the SigTest Path variable. The default value for this variable is
SigTest.exe ver. 3.2.0, which is currently the version required by the PCI SIG. It is
available for download from the PCI SIG website.
2. The conditions of this variable appear on a pop-up. Choose the new condition to apply.
Figure 3 - Variable Setup tab.