Teledyne LeCroy QPHY-SATA - Manual (Page 18)

18
915745 Rev G

To test a SATA host, connect a SATA cable between the LeCroy Protocol Exerciser “To Initiator” port and
the Protocol Analyzer “Target” port. Then connect a second SATA cable between the Protocol Analyzer
“Initiator” port and the host port under test, as shown in the following figure:
2. On the host PC, load the generation file for the desired test pattern in the SASTracer/Trainer software. The
QPHY-SATA installation places these files in C:\Program Files\LeCroy\XReplay\SATA\SASTracer. There
are multiple GenFiles (*.ssg) available, each corresponding to a SATA test pattern on a host or device, their
names reflect the speed, the pattern, and whether they are for a host or device:

LeCroy1_5G Device BIST HFTP.ssg – Places a device in BIST-T with HFTP pattern at 1.5Gb/s

LeCroy3G Host BIST LBP.ssg – Places a host in BIST-T with LBP pattern at 3.0Gb/s