Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 12)

WaveStation 3000 Function and Arbitrary Waveform Generator
Humidity: Maximum relative humidity 80% for temperatures up to 31° C, decreasing linearly to 50% relative
humidity at 40° C.
Altitude: Up to 3,048 m (10,000 ft) at or below 30° C.
Cooling
The analyzer relies on forced air cooling with internal fans and vents. Take care to avoid restricting the
airflow to any part. Around the sides and rear, leave a minimum of 15 cm (6 inches) between the instruments
and the nearest object.The feet provide adequate bottom clearance.
CAUTION. Do not block cooling vents. Always keep the area beneath the instruments clear of paper
and other items.
The instruments also have internal fan control circuitry that regulates the fan speed based on the ambient
temperature. This is performed automatically after start-up.
Calibration
The recommended factory calibration interval is one year. Calibration should be performed by qualified
personnel only.
Extended warranty, calibration, and upgrade plans are available for purchase. To purchase a service plan,
contact your Teledyne LeCroy sales representative or:
[email protected]
Power
AC P OWER
The instrument operates from a single-phase, 100 to 240 Vrms (± 10%) AC power source at 50/60 Hz (± 10%)
and 100 to 120 Vrms (± 10%) AC power source at 400 Hz (± 5%). Manual voltage selection is not required
because the instrument automatically adapts to the line voltage.
P OWER C ONSUMPTION
50 VA (50 W) maximum power consumption when operating with all accessories installed.
G ROUND
The AC inlet ground is connected directly to the frame of the instrument. For adequate protection again
electric shock, connect to a mating outlet with a safety ground contact.
WARNING. Only use the power cord provided with your instrument. Interrupting the protective
conductor inside or outside the oscilloscope, or disconnecting the safety ground terminal, creates a
hazardous situation. Intentional interruption is prohibited.
A PPLYING P OWER
The Power button on the front of the WaveStation controls the operational state of the instrument. Press the
button to switch the instrument AC power On or Off. Always use the Power button to execute a proper shut
down process and preserve settings before powering down. Do not power off by pulling the power cord from
the socket or shutting down a connected power strip.
6 922869 Rev B