Teledyne LeCroy ArbStudio - Manual (Page 163)

Operator’s Manual
922244-00 Rev A 155
B
Creating an Amplitude Modulated Waveform
To create your first Amplitude Modulated Waveform, you must first create
a workspace with Arbitrary Waveform Generator as the Operating Mode
and at least one Analog Channel. See steps 5 and 6 in Arbitrary Waveform
Generator Setup Example (on page 27) for details. If you already have a
workspace open, be sure it meets the aforementioned requirements
before proceeding with the following steps:
1. Double-click the Waveform Sequencer under Channel 1 (Arbitrary)
on the Device Control Tree. (Channel 1 can be any Analog channel
you have configured under Arbitrary Waveform Generator operating
mode in your workspace.)
The Waveform Sequencer is then shown.
2. Press the Add Standard Waveform button.