Channel settings - the general tab, Output impedance, Trigger delay – Teledyne LeCroy ArbStudio User Manual
Page 41: Amplitude correction factor
Operator’s Manual
922244-00 Rev A
33
B
Channel Settings - The General Tab
The General tab is shown by default when the Channel Settings screen is
opened.
Sections of the Channel Settings General tab are explained as follows:
Output Impedance
It allows setting the channel output impedance and it can be set at: 50
Ohm, Low or High Impedance.
Trigger Delay
You can set a delay from the trigger event (start) for each analog output
channel.
Amplitude Correction Factor
The Amplitude Correction Factor (CF) consider the deviation of the load
and of the channel source resistance from the nominal 50 Ohm resistance.
Follow the next steps to evaluate the CF:
Apply to the load a fixed 5 V nominal voltage using the strobe
functionality of the selected channel