TREND IQ3 User Guide - Manual (Page 26)

26 IQ3 Web User Guide TC200631 Issue 2, 02/02/2009
Using IQ3 from a Web browser
4.3.5.3 Set up an Exception’s Times
Once an exception has been added its occupation times must be set up. This is only possible if you have the appropriate
level of authority.
to set up an exception’s times:
View the exceptions as described in the ‘ 1. View exceptions ’ section of this manual.
Click 2. times. The display shown below is displayed that enables the exception’s parameters to be specified.
If there are no time periods set up, or to add another click 3. Create new time Zone Period Module. Unwanted
periods can be removed by clicking next to the period that is to be deleted.
Note that two periods should be added, one to switch occupation on, and one to switch it off.
In the box in the 4. time column enter the start or stop time for a period type. To change the time from a start
time to a stop time or from stop time to a start time in the box in the value column click on or off.
Repeat steps (4) and (5) until all the exception’s times are correctly set. 5.
Click 6. .