Vanguard TTRA-S2 (ATRT-03 S2, ATRT-03A S2, ATRT-03B S2, Tri-Phase) - Manual (Page 23)

REV 2 TTRA-S2 VERSION 1.x SOFTWARE MANUAL
20
4.8 Working with Tabulated Test Results
Once a test record has been retrieved (see sections 4.1 and 4.2 for instructions), the record
details will be displayed as shown:
The menus on the menu bar will also change to provide additional options relevant to working
with a test record.
NOTE
You can edit the test record header information (such as Company, Location,
Circuit, Operator, etc.) by entering data in the corresponding fields at the top of
the screen.
You can also edit the H Voltage, H Tap, X Voltage, and X Tap values. If these
values are changed, the calculated ratio and deviation will be automatically re-
calculated by the TTRA-S2 software.
4.8.1. Printing the Tabulated Test Results
To print the tabulated test results:
1. Click on the Print menu. The print dialog box will appear.
2. Select the printer to print to and make any necessary changes to the printer’s
parameters and then click on the “OK” button. The test results will be printed. A sample
test record printout is shown in Figure 3.