Vanguard ATRT-03_03B User Manual
Page 87
ATRT-03, ATRT-03A, AND ATRT-03B USER’S MANUAL
REV 7
81
4.0 DIAGNOSTICS,
VERIFICATION, AND TROUBLESHOOTING
4.1
Performing an H and X Cable Diagnostic Test
Use the steps below to perform a diagnostic test on the H and X cables:
a. Start from the “START-UP” menu:
Press the
[4]
key (DIAG).
b. The following screen will be displayed:
Press the
[1]
key (CABLE TEST).
c. The following screen will be displayed:
Connect the H and X cables per the on-screen instructions and press the
[ENTER]
key.
d. The following screen will be displayed while the cables are being tested:
The screen will be updated with the status of each test as shown:
NOTE
“NOT OK” will be displayed for a failed diagnostic test.
Press any key to return to the “START-UP” menu.
CABLE TEST
H0-X0, H1-X1: OK
H0-X0, H2-X2: OK
H0-X0, H3-X3: OK
CABLE TEST
CABLE TEST
CONNECT:H0-X0, H1-X1
H2-X2, H3-X3
THEN “ENTER” KEY...
1.CABLE TEST
2.VERIFICATION TEST
3.AUTO-DETECT XFMR
1.TEST XFMR 08/23/10
2.SETUP 08:25:15
3.CALCULATOR
4.DIAG 5.QUICK TST