Vanguard CT-7000 S2 - Manual (Page 46)

CT-7000 S2 USER’S MANUAL REV 2
41
Loading a Resistor Type Transducer Setup
Follow the steps below to load a resistor type transducer setup:
a. Start from the “START-UP” menu:
Press the [3] key (SETUP).
b. The following screen will be displayed:
Press the
[2]
key (MEASUREMENT UNITS).
c. The following screen will be displayed:
NOTE
Option 4 (RES ENC) will be available only if the CT-7000 S2 unit has the optional
R1 channel installed.
Press the [4] key (RES ENC).
d. The following screen will be displayed:
Press the [2] key (LOAD SETUP).
e. The following screen will be displayed:
Type the setup number to load using the numeric keypad.
ENTER SETUP NUMBER
TO LOAD (1-9):
RESISTIVE ENCODER
1. CREATE NEW SETUP
2. LOAD SETUP
3. PRINT SETUP DIR
SELECT UNITS:
1. ENGLISH
2. METRIC
3. ROT ENC 4.RES ENC
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. NEXT PAGE
1. TIME BRKR 02/07/11
2. GET RSLT 14:04:05
3. SETUP
4. DIAGNOSTICS